WelcomeUser Guide
ToSPrivacyCanary
DonateBugsLicense

©2024 Poal.co

609

(post is archived)

[–] 4 pts

Why not just snap it off inside? Or is that illegal?

[–] 10 pts

Well, then it becomes damaging something that doesn't belong to you.

Those jacks are usually just attached to the board with solder pins, and the jack itself itself isn't designed to hold the plug with such force that you could shear it off - you'd probably break the jack first.

You could cut the plug portion off the body and jam that in, or even superglue it, but I guarantee you most people aren't smart enough to figure out why something like this happened and will spend a decent amount of time (and perhaps a service call) trying to fix it.

[–] [deleted] 8 pts

You want the sort that is good for soldering to a coax cable and then you clip it until it is flush or just barely a push pin on top.

I had a universal remote to shut down BET when the student union became rap music central.

[–] 2 pts

or you just use a short nail

[–] 0 pt

That can work if you get one big enough to break the contact on the jack or can short out the connection.

[–] 8 pts

That's what she said

[+] [deleted] 1 pt
[–] 1 pt

It'll most likely break the audio jack. Cut the backshell off at the base of the pins, then just use the tip of your key to push it all the way in, leaving nothing exposed which could be grasped to help remove it from the hole