I used autocad. I didnt know that about mdf, that sucks, used to work in a shop that used it a lot. Rip.
I used autocad. I didnt know that about mdf, that sucks, used to work in a shop that used it a lot. Rip.
Turned out good I think. I didnt paint that shit thank god but I did fill, caulk everything. I did the drawings so I could figure out the spacing beforehand and from floor to ceiling I was only off half an inch over 16 feet. I blame the shitty framing and not even close to flat drywall. Used pine again, mdf would have been better but way more expensive.
Turned out good I think. I didnt paint that shit thank god but I did fill, caulk everything. I did the drawings so I could figure out the spacing beforehand and from floor to ceiling I was only off half an inch over 16 feet. I blame the shitty framing and not even close to flat drywall. Used pine again, mdf would have been better but way more expensive.
(post is archived)