Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2024 Poal.co

Turned out good I think. I didnt paint that shit thank god but I did fill, caulk everything. I did the drawings so I could figure out the spacing beforehand and from floor to ceiling I was only off half an inch over 16 feet. I blame the shitty framing and not even close to flat drywall. Used pine again, mdf would have been better but way more expensive.

Turned out good I think. I didnt paint that shit thank god but I did fill, caulk everything. I did the drawings so I could figure out the spacing beforehand and from floor to ceiling I was only off half an inch over 16 feet. I blame the shitty framing and not even close to flat drywall. Used pine again, mdf would have been better but way more expensive.

(post is archived)

You are currently inside a comment thread.
Click here to see all the comments (14).
[–] • 1 pt (edited )

Nice work. What program did you use to draw it?

MDF is carcinogenic, you did yourself a favor not using it

[–] • 0 pt

I used autocad. I didnt know that about mdf, that sucks, used to work in a shop that used it a lot. Rip.