What really caught my eye in this video was the brass "hammer" at 22m 35s. Pure genius.
What really caught my eye in this video was the brass "hammer" at 22m 35s. Pure genius.
The spanner-hammer?
Yeah, I need to make one of them too. It's a 3/4 ring spanner with a brass "hammer" on the other end and is used to loosen the drawbar and then tap it to release the locked taper (my mill is a MT4 spindle).
Here's a short video of Joe Pie making one: https://poal.co/s/Machining/682930
The spanner-hammer?
Yeah, I need to make one of them too. It's a 3/4 ring spanner with a brass "hammer" on the other end and is used to loosen the drawbar and then tap it to release the locked taper (my mill is a MT4 spindle).
Here's a short video of Joe Pie making one: https://poal.co/s/Machining/682930
(post is archived)