I usually just increase the bottom layers and then use a mortising bit to lay in a flush magnet. It works for me!
I usually just increase the bottom layers and then use a mortising bit to lay in a flush magnet. It works for me!
Archive: https://archive.is/1Ykca
From the post:
>Adding magnets to a 3D print can be very useful in a design, but there are some things that can trip you up if you’re not away of them. In a recent video by [Lost in Tech] some of the essentials are covered, including why you shouldn’t get magnets near most extruder nozzles or the printing bed. The easiest method is of course to add magnets in after printing, using friction fit with or without ribs, or with a dab of glue. Here making sure that the magnet stays in place is the trick, as you do not want the magnet to get lost or end up in the tummy of a curious pet or toddler.
Archive: https://archive.is/1Ykca
From the post:
>>Adding magnets to a 3D print can be very useful in a design, but there are some things that can trip you up if you’re not away of them. In a recent video by [Lost in Tech] some of the essentials are covered, including why you shouldn’t get magnets near most extruder nozzles or the printing bed.
The easiest method is of course to add magnets in after printing, using friction fit with or without ribs, or with a dab of glue. Here making sure that the magnet stays in place is the trick, as you do not want the magnet to get lost or end up in the tummy of a curious pet or toddler.
You are currently inside a comment thread.
Click here to see all the comments (3).