Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2024 Poal.co

1.4K

I've been trying to print my final Christmas kit card and it's not going so well. It was an 11 hour print and it failed at 9.5 hours. I think one of the walls was too thin and it collapsed. So I increased the size about 20 percent to beef everything up a bit which made it into a 14 hour print. It failed again at about the 12 hour mark. Some error about the print nozzle temperature being abnormal. I have followed all the troubleshooting and repair steps a dozen times and nothing is having any effect at all. I have ordered a new complete print head and it's going to take a week to get here. I also opened a support ticket to see what they can do to help me. I've seen this problem on a few different posts and there seems to be no consensus on what the actual problem is or how to fix it. It seems different things have worked for different people but in some cases it seems that nothing works. I'm pretty bummed out.

I've been trying to print my final Christmas kit card and it's not going so well. It was an 11 hour print and it failed at 9.5 hours. I think one of the walls was too thin and it collapsed. So I increased the size about 20 percent to beef everything up a bit which made it into a 14 hour print. It failed again at about the 12 hour mark. Some error about the print nozzle temperature being abnormal. I have followed all the troubleshooting and repair steps a dozen times and nothing is having any effect at all. I have ordered a new complete print head and it's going to take a week to get here. I also opened a support ticket to see what they can do to help me. I've seen this problem on a few different posts and there seems to be no consensus on what the actual problem is or how to fix it. It seems different things have worked for different people but in some cases it seems that nothing works. I'm pretty bummed out.
You are currently inside a comment thread.
Click here to see all the comments (6).
[–] • 1 pt

Are you controlling the temps on the nozzle? What does the display say the temps are at if it's showing them. I had to bring mine down because the everything was getting too hot (summer where I am) and my filament says between 215-205°c so I have it so the first layer at 215°c then down around 207°c and seemes to print okay for 2-3h prints.

Last time I tried 5h the top few layers just got messed up and that's when I found I should be changing it.

Hope you get an answer!

[–] • 1 pt

I can't even print anything. When I start a new print job the bed starts warming and then it just stops with an error code that the nozzle temperature is abnormal. Before it even starts to heat it.

[–] • 1 pt

Oh damn that sucks! Sorry man :⁠(