![Interdasting [1200x675 - 142KB]](https://pic8.co/sh/QD7drr.jpg){kind=link}
What am I looking at? A 3D printed AR lower? And what’s that thingamajobber near the safety?
What am I looking at? A 3D printed AR lower? And what’s that thingamajobber near the safety?
And what’s that thingamajobber near the safety?
This receiver prints in two parts because they wanted concentric layer lines in the buffer tube mount. the weird bar is a tension bar that holds the two parts together at the proper angle. I personally think there are better designs... check out the U-Bar and U-Bolt frames
> And what’s that thingamajobber near the safety?
This receiver prints in two parts because they wanted concentric layer lines in the buffer tube mount. the weird bar is a tension bar that holds the two parts together at the proper angle. I personally think there are better designs... check out the U-Bar and U-Bolt frames
Yes.
Not sure.
Yes.
Not sure.
(post is archived)