Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2025 Poal.co

952

Measure up, mark your line(s).

https://pic8.co/sh/Cs8VYo.jpg

Position your saw so that the blade lines up with your line, then line your guide up with the saw. Square up the block and clamp it down.

https://pic8.co/sh/ek2NvZ.jpg

Using that scrap wood guide for the circular saw's guard, you will make a perfectly flat and square cut.

https://pic8.co/sh/kwAtjC.jpg

Measure up, mark your line(s). https://pic8.co/sh/Cs8VYo.jpg Position your saw so that the blade lines up with your line, then line your guide up with the saw. Square up the block and clamp it down. https://pic8.co/sh/ek2NvZ.jpg Using that scrap wood guide for the circular saw's guard, you will make a perfectly flat and square cut. https://pic8.co/sh/kwAtjC.jpg

(post is archived)

You are currently inside a comment thread.
Click here to see all the comments (11).
[–] • 1 pt

Another good tip that some people might not know is when you are cutting plywood/mdf whichever, always measure from a factory edge if you can. If you cut a piece dont measure off the cut side because chances are its not going to be 100% straight.

[–] • 0 pt

Yep, and the mill is going to ship a straight cut piece.