most decent psu have internal stuff in them to prevent spikes from getting in and out from them if they fail, i think they called
(OCP) Over-Current Protection Over-current protection (OCP) is a popular protection found in all PSUs with multiple +12V rails, and in most cases, it also protects the minor rails. OCP kicks in when the current in the rails surpasses a certain limit.
.
Over Current / Voltage / Temperature / Power Protection, Under Voltage Protection and Short Circuit Protection
thats the protection for my rosewill photon 750
plus it is getting very clean power from my ups.
my power is a little sketchy here, but has gotten better. my lights will flicker sometimes but i have no worries
and i aint all in there brushing it off, lol. i use low compressed air from a distance, there usually not much cause my case has filters on every opening.
My CPU is a neural-net processor. A learning computer.
Overcurrent protection will shut the voltage rail off if it detects too much current being drawn from the device. This is to protect the regulators from damage. USB ports usually have something similar, they will shut down power if too much is drawn from the port. It just shuts the device off and you usually have to power cycle to reset it. If you have this happen often, you've undersized your supply or it's old, dirty, overheating, or a combination of the three.
The voltage input of a power supply is able to tolerate quite a bit of fluctuation, 100-240VAC is not uncommon these days. If you're in the USA then you're probably never going to see >140VAC on your normal household line. The power supply doesn't give a shit, modern switchers are tolerant by design. It's really high voltage, like lightning, that will still do them in.
A UPS protects from brownouts (<100VAC) or complete failures, and is merely designed to give you some time to shut down safely. Not all UPSes are the same, some provide clean power from the batteries (the output is always run on the inverter,) some just try to switch and hope for the best.
Yes all of this is good, but HW fails to do what its supposed to do all of the time. And there are lots of other reasons why a flash drive might go south, static electricity for example. Presumably your data is important, I can only hope that you have back up copies.
Ask me about the top end UPS we had installed on a server that we tested monthly and everything appeared A-1. And then one weekend the power went out and the UPS didn't kick in. There were 7 VMs on that server, 3 of which were critical.
reasons why a flash drive might go south, static electricity for example. Presumably your data is important, I can only hope that you have back up copies.
if a meteor came crashing thru your window smashing you flash drive, what would you do?
i have back ups, i back up all my important stuff
also, no offense i know its the topic but if you are relying on a flash drive for your important stuff, yeah. as far as static goes i mean if ground... you know im kinda done with this. shit happens electronics do fail. Mostly from heat
you what i think im confused, i thought you were talking about the little flash drives that you plug in.
i dunno i love mine
(post is archived)