WelcomeUser Guide
ToSPrivacyCanary
DonateBugsLicense

©2024 Poal.co

1.1K

I have a USB-3 drive that I use as a tertiary backup when I travel. Every now and then it goes into Read Only mode and I have to try to figure out all over again what to do in order to make it Read/Write again. The Disks utility... manually mounting and unmounting... etc. etc. Any tips or tricks to keep this from happening?

I have a USB-3 drive that I use as a tertiary backup when I travel. Every now and then it goes into Read Only mode and I have to try to figure out all over again what to do in order to make it Read/Write again. The Disks utility... manually mounting and unmounting... etc. etc. Any tips or tricks to keep this from happening?

(post is archived)

[–] 2 pts

I've had some go bad after a few days. It's such a cutthroat business that manufacturers cut corners.

Used to have those old 1 and 2GB Micro Center drives last about 6 months with moderate use before they'd go read only.

[–] 1 pt

That has to be a lot of uses. I still have an eight GB drive I put a Linux ISO on every few months since I bought it like ten years ago.

[–] 1 pt

Some of them were just cheaply made and didn't hold up.

[–] 1 pt

I've had some go bad after a few days. It's such a cutthroat business that manufacturers cut corners.

Used to have those old 1 and 2GB Micro Center drives last about 6 months with moderate use before they'd go read only.

Yeah, I fear I'm going to have to buy a new one eventually. Cest la vie.