Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2026 Poal.co

I am not sure if he saved money or not. Some of the comments are saying all the equipment cost more and others are saying it was a wash. Even if it cost more, the real crime was Porsche charging $2000 for a piece of molded plastic.

I am not sure if he saved money or not. Some of the comments are saying all the equipment cost more and others are saying it was a wash. Even if it cost more, the real crime was Porsche charging $2000 for a piece of molded plastic.
You are currently inside a comment thread.
Click here to see all the comments (11).
[–] • 0 pt

careful on temperature range of "printed" parts

a plane fell down because some printed the engine air inlet and it collapsed (small plane obviously)

[–] • 0 pt

I get what you're saying, but this particular part is more aesthetic. If it fails, the car will give no shits.

[–] • 0 pt

ASA and ABS are good for heat deflection up to about 80 degrees celsius (about 175 Fahrenheit)