Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2025 Poal.co

1.2K

Archive: https://archive.today/PSvej

From the post:

>When you’re spitting out G-Code for a 3D print, you can pick all kinds of infill settings. You can choose the pattern, and the percentage… but the vast majority of slicers all have one thing in common. They all print layer by layer, infill and all. What if there was another way?

Archive: https://archive.today/PSvej From the post: >>When you’re spitting out G-Code for a 3D print, you can pick all kinds of infill settings. You can choose the pattern, and the percentage… but the vast majority of slicers all have one thing in common. They all print layer by layer, infill and all. What if there was another way?

(post is archived)

You are currently inside a comment thread.
Click here to see all the comments (2).
[–] • 1 pt

I have been messing with it on and off with various prints. Especially ones that I have unintentionally broken or failed. I don't have any good advice at this point but it is interesting reprinting something you broke to see if it will work better or break differently the next time around.

The sledgehammer is just to increase infill and not care as much about patterns (patterns do still matter more than you think) but that it my non-expert opinion. I just read a bunch and screw up more often than I intend to ;)