Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2025 Poal.co

So it only happens with large objects that are close to the left side of the build plate. The top layer is AFU. The only thing I can think of is that is where the fan is, on the left side. But this print is only about a half inch tall, so the fan is never blowing directly on the print because the build plate is still well above the level of the fan. It is 10x6 in size but only a half inch tall. The rest of the top came out fine but the left edge is trash. Happened with multiple filaments. I even tried drying the filaments to see if that was it but no luck.

Any ideas?

So it only happens with large objects that are close to the left side of the build plate. The top layer is AFU. The only thing I can think of is that is where the fan is, on the left side. But this print is only about a half inch tall, so the fan is never blowing directly on the print because the build plate is still well above the level of the fan. It is 10x6 in size but only a half inch tall. The rest of the top came out fine but the left edge is trash. Happened with multiple filaments. I even tried drying the filaments to see if that was it but no luck. Any ideas?

(post is archived)

You are currently inside a comment thread.
Click here to see all the comments (18).
[–] • 1 pt

Have you rotated the object 90° to see if it still happens in that corner of the build area?

[–] • 0 pt

Not yet but I am going to give that a try too.