Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2025 Poal.co

1.5K

The four gears at the top were sliced with 4.13.1, tried some variations in print speed and flow there. The anemic POS at the bottom was done with 5.3.0 Everything else same on Ender 3 Pro. Sorry for tater quality, my phone is ooold.

What the eff, yo! Anyone got an idea what's going on there?

P.S.: Had the same shitty result with my Rock 3 and Cura 5.2.2 earlier. Was almost ready to throw the printer out. That's why I tried on the Ender and just out of curiosity sliced with both Cura versions.

Edit: Even the preview looks shitty! https://pic8.co/sh/nrjkDd.png

The four gears at the top were sliced with 4.13.1, tried some variations in print speed and flow there. The anemic POS at the bottom was done with 5.3.0 Everything else same on Ender 3 Pro. Sorry for tater quality, my phone is ooold. What the eff, yo! Anyone got an idea what's going on there? P.S.: Had the same shitty result with my Rock 3 and Cura 5.2.2 earlier. Was almost ready to throw the printer out. That's why I tried on the Ender and just out of curiosity sliced with both Cura versions. Edit: Even the preview looks shitty! https://pic8.co/sh/nrjkDd.png

(post is archived)

[–] • 1 pt

Based on the slicing preview it looks to me like there is a setting determining the amount of segments that are used for matching the surface, and it's set to something too low (sadly I haven't done much with my printer yet so I'm not super familiar with the settings in many of the slicers).