Welcome • User Guide
ToS • Privacy • Canary
Donate • Bugs • License

©2025 Poal.co

476

It was cheap, I needed parts and will need even more in the future so I went for it. I've got it leveled pretty well and it handles a basic bridge test just fine. Currently printing out the Bullseye air duct and then the mount.

Outside of printing printer upgrades, what's some cool, fun, useful things to print? What have you printed that you got the most use or laughs from?

I need to sit down and learn freecad so I can start making custom stuff. That'll take time and practice. Until then, pre-generated stls for me.

It was cheap, I needed parts and will need even more in the future so I went for it. I've got it leveled pretty well and it handles a basic bridge test just fine. Currently printing out the Bullseye air duct and then the mount. Outside of printing printer upgrades, what's some cool, fun, useful things to print? What have you printed that you got the most use or laughs from? I need to sit down and learn freecad so I can start making custom stuff. That'll take time and practice. Until then, pre-generated stls for me.

(post is archived)

You are currently inside a comment thread.
Click here to see all the comments (20).
[–] [deleted] • 0 pt

Good call on the springs. I'll pick some up. I'm already planning the other upgrades, have a top filament guide already but need to do the one by the z screw. I also need to pull out some calipers and check the z screw measurements to make sure its good. So far there's no signs of binding.

[–] • 1 pt

Mine did not start z axis binding until about 1000 print hours. Watch for it. E3Pros are notorious for it.